How To Attach Bathroom Sink To Wall

Install the sink if your sink includes a mounting plate you can use that for a template to drill your pilot holes.

How to attach bathroom sink to wall.

This metal or plastic nut will be located either in the wall or the floor. Turn off the water supply. Check the level again before trimming the shims with a utility knife. Use plumber s putty as you attach the.

Prepare the faucet drain and pop up. Be sure to use a masonry. If the holes are not completely lining up or you want a more. Loosen the slip nut at the top of the p trap.

Locate the large nut that connects the sink to the drain and disconnect it. Measure and mark the location of the sink on the wall again. The valves are typically under the sink. Use your hands or locking pliers to unscrew the nut.

If the cabinet has a back you ll need to measure and cut three holes for the two supply lines and the drain. Then turn on the faucet. Remove the entire trap if necessary. Drill your pilot holes for the lag screws which should be included with your wall mount sink.

Lift the sink slightly while tightening the nuts with a wrench. Lift the back edge of the sink onto the bracket. Attach the sink 1. Two on the rear against the wall and one on each side.

Ideally i would like to mount the sink using only the two rear tabs bolted to the wall. Smear pipe dope onto the threads of the supply line compression fittings and tighten them onto the faucet supply lines. Have a small bucket ready to catch any water. For sinks that do not attach with a bracket ask an assistant to hold the sink at the wall so the upper holes at the rear underside of the sink.

Installing a bathroom sink in a vanity is made easier by the fact that the supply lines and the drain all remain hidden within a cabinet. Slip the sink over the mounting bolts and finger tighten the mounting nuts over the washers. The pockets are not deep enough for the tabs on my sink the holes do not align etc. Mount the sink to the wall.

Verify the toggled wings open once you. Remove the current sink by sliding the edge of a putty knife around the perimeter of the bathroom sink loosening any caulk that connects it. If not turn off the water at the main valve. The standard cast iron brackets available for vintage sinks do not seem designed for this sink s brackets.

Follow manufacturer s directions for the size and depth of. Use the template that comes with the sink to mark the. Attach the vanity to the wall using 3 inch drywall screws. Drill pilot holes into the wall at the marked locations.