How To Adjust Tension Spring On An Overhead Garage Door

This is accomplished by opening the garage door as fully as possible until it hits the stop bolt on the track.

How to adjust tension spring on an overhead garage door.

Open the door fully to relieve the tension on the hinge springs at each side of the door opening. You can adjust the spring tension on a wayne dalton torsion garage door with a few simple tools. If you need to increase the spring tension hook the spring onto a lower hole on the track hanger. This can make the other parts of the garage door last a much longer time.

This will prevent the door from shooting up and breaking your nose when you wind the new springs during an overhead garage door repair. Look for a reddish cone on the torsion spring. This cone has notches in it that are used to adjust the tension in the torsion spring. Once your garage door is secured remove the spring hook from the track hanger which will allow you to move the hook and adjust the spring s tension.

Lower the door and use 2 metal rods to adjust the tension in the spring. Clamp a locking pliers or a c clamp to the track just above one of the rollers. You must release the tension on the garage door springs before attempting adjustment or replacement. The cone is on the torsion spring on the left side away from the center of the garage door.

Then insert another rod into a hole below the rod you already inserted. Lower the garage door clamp or bolt it shut so it can t open and insert 1 metal rod into 1 of the holes around the perimeter of the spring. How to safely adjust your garage door spring. If the door lifts by itself or if it is hard to pull down you will need to unwind the springs.

Install a vertical two by four brace at the outer edge of the door to prevent the door from falling. Also yank the cord and unplug the garage door opener before you start any garage door spring repair.