How To Adjust Garage Door Springs Diy

Adjust the springs on both sides of the door the same way.

How to adjust garage door springs diy.

Use a metal rod to stick in the first notch of the cone. Detach the old spring from both ends and replace it with the new one and replace the pulleys as well if they are worn out. This video will show you how to repair a mis aligned garage door cable. You must release the tension on the garage door springs before attempting adjustment or replacement.

Retest the door. This is accomplished by opening the garage door as fully as possible until it hits the stop bolt on the track. This can make the other parts of the garage door last a much longer time. Hold the garage door in this position by attaching a c clamp to the track at a point below the lowest door roller wheel.

The cone is on the torsion spring on the left side away from the. The other is attached to a pulley connected to the cable. How to adjust a torsion spring garage door step 1. If the door was closing too quickly move the spring to the next higher hole on the bracket.

Adjust the spring into the proper position and make sure your garage door closes all of the way. The rod will need to be at least 18 inches long and 1 2. To adjust your garage door s side mounted springs first open your door fully and secure it in place with a c clamp below the bottom roller. One end of the spring is connected to the garage door track or frame.

If your garage door cable is at an angle or l. How to safely adjust your garage door spring. Once the spring is free of tension remove from its track hanger. Diy garage door repair and save money.

This video applies t.