How To Add A Pull Switch To A Wall Light

When you tighten the screw it will pull the wire down.

How to add a pull switch to a wall light.

This is the hot wire and the one you ll connect to the hot side of the new double switch. All that to say that this is the way that one can macgyver any wall sconce to have a switch. Tighten those screws with a slotted screwdriver. To wire the ceiling fixture to the new wall switch first connect the copper grounding wire to the fixture.

First make sure the toggle switch fits between the plate and wall. Insert a new section of electrical cable of the same. Then splice the fixture s black lead into the new black wire. Prep for installing toggle switch.

Place the light switch inside the wall box and tighten the mounting screws with a phillips screwdriver. To attach a wire to a screw bend the bare wire to the left and slip it over the screw. What i want to do is i have bought a mini pull switch 2a from tlc and drill a small hole to fix it to the light fitting base i. If you are adding a switch to a finished wall see fish wires through walls for directions.

After removing the black wire to the fixture s lead splice it into the new white wire. Restore power and operate the light with the new switch. With the light switch turned off hold the noncontact voltage detector against each of the wires connected to the switch. Determine where the pull switch will fit inside the socket and drill a hole large enough for the nut attachment of the switch to fit through.

Place the cover plate over the switch and secure it with the holding screws. Take note of which wire causes the tester to light up. I have bought some wall lights that dont have a internal pull cord on them as the lights are currently wired from the ceiling rose with a live feed coming in. Using a drill press make the hole for the switch in each plate.

Pass the chain through the hole and tighten the switch to the socket with the nut provided.