How High Should Garage Door Photo Eyes Be Mounted

One sensor sends a beam of light to the other.

How high should garage door photo eyes be mounted.

If the photo eye senses an obstruction it stops the door from closing and potentially prevents damage or injury to a vehicle. Use a clean cloth and mild cleaner to wipe down the lens. This law is grandfathered in so you can still have pre 2012 openers that do not meet this code serviced. The object under the door needs to break the sensor s infrared beam in order for the sensor to work.

The door should stop and began to open within 2 seconds of contacting the block. Fixing the problem with garage door photo eyes. If this beam is broken due to some sort of obstruction the garage door won t close. How to fix a garage door s photo eye.

Being as low to the ground as they are the photo eye can become covered in dust cobwebs or debris. Break the safety eye beam. Other safety products are available and often chosen to supplement the mandated safety. If the eyes are installed higher a person or pet could get under the beam and not be detected by the photo eyes thus the standard manufacturer s recommendation of 4 to 6 above the floor.

This would require either a photo eye mounted 6 above the floor or an electric safety edge. The photo eyes mentioned above should not be installed higher than six inches above the garage floor. Also how to manually close and disconnect. Safety sensors include two mounted sections one on each side of the garage door opening.

Direction and the garage door should return to the fully open position. Look for obstructions adjust the sensors to get a solid green light. The photo eyes safety sensors are located about six inches off the ground to the right and left of your garage door. When the beam is broken the garage door movement should reverse.

As a general rule garage door sensors should be mounted not more than six inches above the floor. To test the safety eye system start the door closing then use a controlled obstruction to. The sensors use two photo eye lenses that transmit an infrared beam between them. The photo eye of an automatic opening garage door is a safety feature.

To test the reverse feature as i mentioned earlier place a 2 4 or similar object on the ground under the center of the garage door.