This is typically located on the side or base.
How do you take a doorknob off locked door closet.
Look for a thin slot or a recessed hex head setscrew on the lock side of the doorknob.
Our quick video shows you how si.
Thread the screwdriver through the large spindle.
If the knob has a recessed setscrew turn the setscrew counterclockwise with a correctly sized.
Apply a bit of pressure to the paper clip to trigger a release button inside the hardware.
Unscrew your door knob begin by holding the door knob securely in place.
Then pry off the round decorative plate called the rose to expose the screws that hold the lockset onto the door.
Don t worry removing a door from its hinges is an easy task that can be done in under a minute.
Take a flat head screwdriver and push in the latch in order to remove the knob.
These screws hold the entire knob and latch assembly together.
Many door knobs have trim plates that cover the screws so removing them can be a bit tricky if you ve never done it before.
Pull the spindle from the center of the latch if applicable.
If any screws are exposed during this process remove them to release the lock and remove it from the door.
Use a drill driver to remove the longer mounting screws.
So the only way to get a door open when you re on the outside and it s locked from the inside is to remove the door from its hinges.
Use the screwdriver to push the opposite side of the doorknob from the door and latch.
To simply remove the door knob itself there are much fewer steps.
Best of all it only requires a hammer and a small screwdriver.
In this situation you will need to locate the latch on the side of the knob.
Look closely at the shank of the interior doorknob and you ll see a tiny slot or hole.
Using a philips head screwdriver turn counterclockwise to unscrew a knob with standard hex head screws.
Use a phillips screwdriver to remove the screws that run from one backing plate to its opposite through the bore hole.
Straighten a paper clip and insert it into the hole.
If your knob has a pinhole or small slot opening use a flathead screwdriver to push it inward.
Once triggered the lever or lock trim can be removed from the door.
