Setting the door handle 1.
How do you install a door handle.
In this kit the hole for the allen key is at the bottom of the faceplate.
Remove the two screws holding the strike plate in place on the door jamb and install the new one in the same position.
Slide the faceplate over the door handle and snap it into place.
Screw the faceplate into the.
It must line up with the holes in the latch assembly to function properly.
Repeat this process to attach the other faceplate.
Watch this step by step video guide from bunnings warehouse and learn how to make sure the handles.
Step 1 start replacing door handle assembly.
Screw on the handles.
Install the inside.
Install the outside handle if your new door handle attaches to the door at a point below the lower borehole.
Installation instructions start by removing your old storm door handle.
If your new handle set features a backplate position the back plate and fasten it onto the door rail with the plate.
Installing a lever door handle quickly and easily.
Install both knobs by sliding the spindle through the slot in the latch.
Installing a door handle is a relatively easy diy project.
Use the allen key provided in the door handle kit to lock and secure the faceplate.
First take out the old door handle assembly by unscrewing the two screws that secure the.
It should feel slightly snug when the two parts join.
With the latch assembly in place slide the door handle with the attached cylinder into place.
Align the two long screws from the inside knob into the cylinders on the exterior door knob and tighten the screws.
Take out two screws setting in the door edge and slide latch mechanism out.
Step 2 remove latch mechanism.
Trace the handle s faceplate with a pencil.
Set the latch of the door handle into its hole and make distinct marks to.
Install the latch determine whether you want to use a flat rectangular faceplate or a round drive in faceplate.
Place the chisel at a 45 angle and begin to chisel the.
Place the corresponding doorknob or lever on the interior side of the door fitting the two parts together.
Chisel out the faceplate outline with a chisel and hammer.
