It must line up with the holes in the latch assembly to function.
How do i install a door handle.
Screw the screws into the holes.
Put the new lever assembly in place.
Follow our instructions for installing a front door handle and lockset to get a fresh look you love and enhance your home s curb appeal.
Many kits come with both options.
Storm door handles are easy to install or replace yourself.
Drill into the receiver hole.
This is the interior portion of your knob or lever for privacy knobs and levers you ll want to be sure the push button lock is on the inside.
With utility knife mark new spot for strike plate and trim.
Previous step next step.
Installing a door handle is a relatively easy diy project.
This is the exterior portion of your hardware with the spindle extending from the back.
Move the wedge as you change the side of the door you re working on.
Drill new openings and install.
The spring operated bolt with a beveled face to permit a latching action when the door closes.
Remove the old door knob latch and strike plate.
Look into keyed entry door knobs also called privacy knobs portable door locks or top of door locks.
Watch this step by step video guide from bunnings warehouse and learn how to make sure the handles.
If your new handle matches the hole configuration of the old one the entire job should be done in just a few minutes with nothing but a screwdriver or two.
Mark where the door handle will go.
The strike plate is a rectangular metal piece that.
Before you start installing the door handle place a door wedge under the door to stop it from moving while you re working.
If you re in a situation where you cannot or do not want to use a drill to install your lock there are a couple ways of installing an interior door lock without a drill.
Installing a door handle is a relatively easy home project that you can do with a pre made kit.
Put your tape measure on the floor in front of your door and measure up 41 inches from the floor since this is the most common placement for door handles.
Depending on the door you may also need to remove the strike plate to take it out remove the top and bottom screws with a screwdriver and lift it carefully out of the door.
With the latch assembly in place slide the door handle with the attached cylinder into place.
If not take off strike plate.
Install the latch determine whether you want to use a flat rectangular faceplate or a round drive in faceplate.
If you have not already removed the old door knob and latch take it out before you begin installing the new one.
