How Do I Apply Paneling To Walls

Any room with a frp panels installation are easy to clean and hard to stain.

How do i apply paneling to walls.

Like decorative paneling or wainscoting panels applying frp paneling is a simple way to change the look of a room. Only apply the panel adhesive to one section of the wall. Trim the inside edge the edge in the corner of the panel if necessary to allow the panel to hang properly. Load a caulking gun with a tube of panel adhesive and apply a small dab of it on the wall about every 10 inches.

Place the panel on the wall and press it into the adhesive. Place the first piece of paneling in a corner of two walls. Water resistant and durable frp or fiberglass reinforced paneling resist mildew and mold and work great in laundry rooms and bathrooms. The first step in how to install paneling is to remove all wall plates outlets and any nails in the wall.

Secure the paneling to the wall with panel adhesive and finishing nails. Use a level to check the outer edge of the first panel. Adhesive may be used to fasten panels to a smooth well adhered surface. For best results set the paneling in the room for a few days before you install it.

This must be plumb or the remaining panels will necessarily be crooked. Install the panels to the wall studs with finishing nails or a pneumatic nailer. Drive four finishing nails through the top edge of the panel. Repeat every 10 inches 25 4 cm up down and across the section of the wall where the first plywood panel will go.

This will allow it to adjust to the humidity in a room. Apply adhesive to the framing in a wavy pattern. They usually come in 4x8 pieces so to approximate how much you will need first measure the total square footage of the wall or area to be paneled. Wait until you get the paneling up on that section before you move on to another one.

Smear a quarter size amount of the panel adhesive onto the wall. The tubes fit standard caulk guns for an easy method to apply the adhesive. On the back of each panel place a 1 4 bead of adhesive about 1 from the edges of the panel. Position the panel on the wall leaving a 1 4 inch space at the bottom and drive the four nails partway into the wall.

Pull the bottom edge of the panel about 6 inches from the wall and push a block behind the sheet. Gently remove any crown moulding baseboards and trim you plan on using again. Paneling is sold both in boards and sheets but sheets are generally a little easier to install.